Do not share medicines prescribed for you with any other person. Always use LIRAGLUTIDE CIPLA exactly as your doctor or pharmacist has told you to. You should check with your doctor or pharmacist if you are not sure.
The LIRAGLUTIDE CIPLA pen LIRAGLUTIDE CIPLA is a pen which is used to inject doses of 0,6 mg, 1,2 mg or 1,8 mg once a day.
- Each pen contains more than one dose, so it can be used more than once.
- Do not share your pen with anyone else.
Injection needles
- Injection needles are not included with LIRAGLUTIDE CIPLA .
- LIRAGLUTIDE CIPLA is designed to be used with NovoFine TM or BD UltraFine TM injection needles, up to a length of 8 mm and as thin as 32 G.
- Ask your doctor or diabetes nurse which injection needle width (gauge) and length is best for you.
- Use a new injection needle for each injection and dispose of it after use.
Using LIRAGLUTIDE CIPLA
• LIRAGLUTIDE CIPLA is an injection which is given under the skin (subcutaneously).
• Do not inject it into a vein or muscle.
• The best places to give yourself the injection are the front of your thighs, the front of your waist (abdomen) or your upper arm.
• Change the place within the area where you inject each day to reduce the risk of developing lumps under the skin (see section 4 ‘Possible side effects’ ). You can give yourself the injection at any time of the day.
• Before you use the pen for the first time, your doctor or nurse will show you how to use it.
Detailed instructions for use are provided below:
INSTRUCTIONS FOR USING THE PEN
Please read these instructions carefully before using your pen. Your pen comes with 18 mg of liraglutide. You can select doses of 0,6 mg, 1,2 mg and 1,8 mg.
The pen is designed to be used with disposable injection needles up to a length of 8 mm and as thin as 32G (0,25/0,23 mm).
Prepare your pen
Check the name and coloured label of your pen to make sure that it contains liraglutide. Using the wrong medicine could cause severe harm.
Pull off the pen cap.
Pull off the paper tab from a new disposable needle. Screw the needle straight and tightly onto your pen.
Pull off the outer needle cap and keep it for later.
Pull off the inner needle cap and dispose of it. Always use a new needle for each injection. This reduces the risk of contamination, infection, leakage of liraglutide, blocked needles and inaccurate dosing.
Be careful not to bend or damage the needle. Never try to put the inner needle cap back on the needle. You may stick yourself with the needle.
Caring for your pen
- Do not try to repair your pen or pull it apart.
- Keep your pen away from dust, dirt and all kinds of liquids.
- Clean the pen with a cloth moistened with a mild detergent.
- Do not try to wash, soak or lubricate it – this can harm the pen.
Important information
- Do not share your pen or needles with anyone else.
- Keep your pen out of the reach of others, especially children.
With each new pen, check the flow
Check the flow before your first injection with each new pen. If your pen is already in use, go to ‘Select your dose’, step L.
Turn the dose selector until the flow check symbol lines up with the pointer. Hold the pen with the needle pointing up. Tap the cartridge gently with your finger a few times. This will make any air bubbles collect at the top of the cartridge.
Keep the needle pointing up and press the dose button until 0 mg lines up with the pointer. A drop of liraglutide should appear at the needle tip. If no drop appears, repeat steps E to G up to four times. If there is still no drop of liraglutide, change the needle and repeat steps E to G once more. Do not use the pen if a drop of liraglutide still does not appear. This indicates the pen is defective and you must use a new one.
If you have dropped your pen against a hard surface or suspect that something is wrong with it, always put on a new disposable needle and check the flow before you inject.
Pull off the pen cap.
Check the name and coloured label of your pen, to make sure that it contains Liraglutide 6 mg/mL solution for injection.
Attach the Needle
Remove protective tab from outer needle cap.
- Push outer needle cap containing the needle straight onto the pen, then screw needle on until secure (See Figure I).
- Pull off outer needle cap. Do not throw away (See Figure J).
- Pull off inner needle cap and throw away (See Figure K). A small drop of liquid may appear. This is normal.
Select your dose
Always check that the pointer lines up with 0 mg. Turn the dose selector until your needed dose lines up with the pointer (0,6 mg, 1,2 mg or 1,8 mg). If you selected a wrong dose by mistake, simply change it by turning the dose selector backwards or forwards until the right dose lines up with the pointer. Be careful not to press the dose button when turning the dose selector backwards, as liraglutide may come out.
If the dose selector stops before your needed dose lines up with the pointer, there is not enough liraglutide left for a full dose. Then you can either:
- Split your dose into two injections: Turn the dose selector in either direction until 0,6 mg or 1,2 mg lines up with the pointer. Inject the dose. Then prepare a new pen for injection and inject the remaining number of mg to complete your dose. You may only split your dose between your current pen and a new pen if trained or advised by your healthcare professional. Use a calculator to plan the doses. If you split the dose wrong, you may inject too much or too little liraglutide.
- Inject the full dose with a new pen: If the dose selector stops before 0,6 mg lines up with the pointer, prepare a new pen and inject the full dose with the new pen.
Do not try to select other doses than 0,6 mg, 1,2 mg or 1,8 mg. The numbers in the display must line up precisely with the pointer to ensure that you get the correct dose. The dose selector clicks when you turn it. Do not use these clicks to select your dose. Do not use the cartridge scale to measure how much liraglutide to inject – it is not accurate enough.
Inject your dose
Insert the needle into your skin using the injection technique shown by your doctor or nurse. Then follow the instructions below: Press the dose button to inject until 0 mg lines up with the pointer. Be careful not to touch the display with your other fingers or press the dose selector sideways when you inject. This is because it may block the injection.
Keep the dose button pressed down and leave the needle under the skin for at least 6 seconds. This is to make sure that you get your full dose. Keep your thumb on the injection button until you remove the needle from your skin.
Change (rotate) your injection sites within the area you choose for each dose. Do not use the same injection site for each injection.
Pull out the needle. After that, you may see a drop liraglutide at the needle tip. This is normal and does not affect your dose. Guide the needle tip into the outer needle cap without touching the needle or the outer needle cap. When the needle is covered, carefully push the outer needle cap completely on. Then unscrew the needle. Dispose of it carefully and put the pen cap back on.
When the pen is empty, carefully dispose of it without a needle attached. Please dispose of the pen and needle in accordance with local requirements. Always remove the needle after each injection, and store your pen without a needle attached. This reduces the risk of contamination, infection, leakage of liraglutide, blocked needles and inaccurate dosing. Caregivers must be very careful when handling used needles – to prevent needle injury and cross-infection.
How much to inject.
• The usual starting dose is 0,6 mg once a day.
• Your doctor will tell you how long to keep taking this dose. It will be for at least one week.
• Your dose will then be increased to 1,2 mg once a day. Do not change your dose unless your doctor has told you to. Do not use more than 1,8 mg per day.
Testing your blood sugar levels
• You will not need to test your blood sugar levels each day in order to adjust your dose of LIRAGLUTIDE CIPLA .
• However, if you are taking a sulphonylurea medicine as well as LIRAGLUTIDE CIPLA, your doctor may tell you to test your blood sugar levels to begin with. This will help your doctor to decide if the dose of the sulphonylurea needs to be changed.
If you use more LIRAGLUTIDE CIPLA than you should
In the event of overdosage, consult your doctor or pharmacist. If neither is available, contact the nearest hospital or poison centre.If you use too much of LIRAGLUTIDE CIPLA, you may feel sick (have nausea) be sick (vomit) or experience low blood sugar (hypoglycaemia). Please refer to section 4 ‘Possible side effects’ for early warning signs of low blood sugar.
If you forget to use a dose of LIRAGLUTIDE CIPLA
• If you forget a dose, inject LIRAGLUTIDE CIPLA as soon as you remember it.
• However, if it is more than 12 hours since you should have used LIRAGLUTIDE CIPLA, skip the missed dose. Then take your next dose as usual on the following day.
• Do not administer a double dose or increase the dose on the following day to make up for forgotten individual doses.
If you stop using LIRAGLUTIDE CIPLA
Do not stop administering LIRAGLUTIDE CIPLA without telling your doctor. If you stop using it, your blood sugar levels may increase.